Dulux Bathroom Colour Mix 2.5ltr

CA8657

Dulux Easycare Bathroom Paint Soft Sheen Light Base 2.5 Litre

Number of coats: 2 coats

Usage Details

Preparing the surfaces: To get the best results with Dulux Bathroom, make sure surfaces to be painted are sound, clean and dry (new surfaces particularly must be fully dry). Before surface preparation, read the information in the Safety, Health And Environmental Information section about old lead paints. Any surface defects should be filled with the appropriate "http://www.polycell.co.uk/products/fillers.jsp Polycell Polyfilla product. For best colour consistency, purchase sufficient mixed paint for each job including touch in at one time from the same source. General preparation: Remove any loose or flaking paint. Where necessary, wash the surface to remove dirt, grease etc. Treat surfaces affected by mould growth with a suitable fungicidal wash. Sand down to remove any sheen. Seal new, bare and porous surfaces with a thinned coat of Dulux Bathroom (10% clean water). Porous surfaces, including previously unpainted patterned textured ceiling coatings, new buildings that have a plasterboard finish and wallcoverings that are suitable for painting (not vinyl or washables) should be sealed with Dulux Plaster Sealer for best results Stir thoroughly with a palette knife or similar implement before use. For normal use thinning is not required. However, in hot weather and warm environments, up to 10% clean water may be added and stirred in to ease application. Apply 1 or 2 coats using a suitable brush or roller. Allow a minimum of 6 hours between coats. When conditions are colder, more time must be allowed for the first coat to dry. Allow a minimum of 24 hours for the paint to fully dry. Precautions: Do not use this paint on radiators and other heated surfaces. Do not use abrasive cleaners to clean the painted surface. Vigorous scouring may impair the finish. Do not use or store the paint in extremes of temperature. Clean the painted surface using a very soft cloth and clean soapy water. Protect the paint from frost. Very slight variation in colour may occur between different cans of coloured paint. When using more than one can it is adviseable to mix them together in a larger container or finish in a corner before starting a new can.

Painting: Stir thoroughly with a palette knife or similar implement before use. For normal use thinning is not required. However, in hot weather and warm environments, up to 10% clean water may be added and stirred in to ease application. Apply 1 or 2 coats using a suitable brush or roller. Allow a minimum of 6 hours between coats. When conditions are colder, more time must be allowed for the first coat to dry. Allow a minimum of 24 hours for the paint to fully dry.

Cleaning: Cleaning up after painting: Remove as much paint as possible from brushes and rollers before cleaning with water.

Storing: Store paint in dry conditions and protect from extreme temperatures.

Recycling: Don’t waste unwanted paint! Leftover product may be taken to a Community RePaint collection point. Make a small difference to someone else at http://www.communityrepaint.org.uk